Mods for the ARE/AEA HamLink: 1. If you are using an ARE ARE-60, chances are you have an old version of the firmware. The latest version is Ver. 4.0 - (2 EPROMS) Call AEA (Hadley Allhands) for more info on how to obtain the new firmware. 2. Change R14 from 130K to 248K if you have Touch Tone falsing problems. The tone detection was much too fast and would cause HamLink to false. In the middle of a QSO, often the radio would QSY some where else. The 248K resistor solved this problem. Hamlink still decodes tone very fast (setting #6 or slower on the Alinco DJ-580) Careful when changing this resistor as the foil near the 8870 IC comes up from the board very easily. 3. Older units used a 13K resistor at R10 to determine confirmation beep level. It was much too loud so they put in a 100K resistor in all their newer units. This was still too loud for me so I replaced it with a 1M 10 turn pot. This allows me to adjust the level to my taste. 4. If you are using HamLink with a Yaesu FT-1000 or FT-990 you might have problems getting the unit to communicate with the radio. ( Via the CAT port). If this is the case, place a 2.7K resistor between pins 1 and 2 on the CAT DIN connector (serial date + ground). 5. I moved the internal programming jumper to a toggle switch on the back panel. Same for the reset switch. (Drilled 2 holes on back panel). Brought out an extension plug from the internal RJ-11 jack with a double female connector. With this arrangement, I don't have to open the HamLink every time I want to program the unit. 6. Bug that remains; #71# - pin 9 on the D25 connector should go high for 100 mS after the command is received and does not. All other ON-OFF functions work fine. AEA was made aware of the problem in June, perhaps there has been a fix since.